Design And Construction Of A Free Energy Generator

This Paper deals with the study of free energy and its generation using flywheel system. The energy storing capacity of flywheel is used to generate extra amount free energy. This extra energy is used to run s the other electrical appliances. It consist of A.C. motor of half horsepower capacity is used to drive a series of belt and pulley drive which form a gear-train and produces over double rpm at the shaft of an alternator. The intriguing thing about this system is that greater electrical output power can be obtained from the output of the alternator than appears to be drawn from the input motor. It is done with the help of Gravity wheel. The gravity wheel or flywheel is coupled with the gear-train in order to produce more extra energy or free energy. The overall study is done with various parameters of flywheel to obtain the maximum free energy out of the system. This free energy is getting free of cost.

TABLE OF CONTENTS

COVER PAGE

TITLE PAGE

APPROVAL PAGE

DEDICATION

ACKNOWELDGEMENT

ABSTRACT

CHAPTER ONE

INTRODUCTION

1.1   BACKGROUND OF THE PROJECT

• OBJECTIVES OF THE PROJECT
• SIGNIFICANCE OF THE PROJECT
• ADVANTAGES OF THE PROJECT
• AIM OF THE PROJECT
• SCOPE OF THE PROJECT
• BENEFIT OF THE PROJECT
• LIMITATION OF THE PROJECT
• METHODOLOGY
• PROJECT ORGANISATION

CHAPTER TWO

LITERATURE REVIEW

• LITERATURE SURVEY OF THE STUDY
• THE EVOLUTION OF THE FREE ENERGY OPTION
• REVIEW OF FREE ENERGY TECHNOLOGY
• COST OF CONSTRUCTING FREE ENERGY GENERATORS FOR DOMESTIC USE
• HISTORY OF FLYWHEEL

CHAPTER THREE

SYSTEM METHODOLOGY

3.1     WORKING PRINCIPLE

• SYSTEM LAYOUT
• DESIGN CALCULATION

CHAPTER FOUR

• CONSTRUCTION PROCEDURE AND TESTING ANALYSIS
• ASSEMBLING OF SECTIONS
• TESTING OF SYSTEM OPERATION

CHAPTER FIVE

• CONCLUSION
• RECOMMENDATION
• REFERENCES

CHAPTER ONE

1.0                                                        INTRODUCTION

In today’s difficult economic times, with energy prices that have been rising slowly but steadily for years, many homeowners are taking a serious looks at alternative or “green” energy systems to reduce their home power bill.  Solar panels are perhaps the most popular, followed by wind turbines, and then geothermal heat pumps.  There’s another clean, renewable power system, however, that few people have heard of and that is extremely well suited to residential use.

It’s a free power generator, also known as a perpetual motion generator, which uses perpetual motion magnets to generate electricity.

A perpetual motion generator is very much like any electrical generator. Instead of using fossil-fuel powered steam turbines to turn the rotor of the generator, however, it uses the push-pull effect of polar opposite perpetual motion magnets to keep the rotor spinning indefinitely.

Free generators are very versatile.  They are relatively small-roughly the size of a garbage can-so they don’t take up much space even in a small home.  Furthermore, perpetual motion magnets are not affected by temperature, so magnetic generators can operate in extreme conditions.  Although you may not want to leave it outside exposed to the wind, rain, and snow, they’ll do just fine in an unheated or un-air conditioned garage, basement, or attic.

Unlike wind and solar power, which only generate electricity at certain times and under certain conditions, magnetic generators operate continuously.  Moreover, the perpetual motion magnets produce a stable, constant stream of electricity at a rate of about 24 kilowatts a day.  Although this may not be enough to power you entire home, it can reduce you power bill by (depending on the size of your house) between thirty and fifty percent.

Finally, magnetic generators are completely safe.  They don’t burn fuel or release greenhouse gasses or any other toxic byproduct.  They are safe for you, your family, your home, and the environment.

The main aim of this work is to have a Free Energy Generator – It is a Self Powered system which generates electricity, or we can say it Recycles Electricity Fed to it, for itself and outside the system, continuously.

1.1                                         BACKGROUND OF THE PROJECT

Nikola Tesla once said that, all people should have energy sources for free to fulfil their daily needs . There is electricity everywhere present in limitless quantities and can drive the world’s equipment without the need of non-renewable sources such as gas, coal or oil.

Free energy means the zero cost energy. Mechanical energy which drives windmill by using the blowing force of wind, or Solar energy in solar cell which is converts into DC current and store in batteries . Other energies obtained are from wind power, water power & telluric power. Free energy generator is used to generate these types of energy.

Free energy suppression is the notion that corporate energy interests intentionally technologies that may provide energy at minimum cost. All other remaining untouched forces of nature which are well familiar in the scientific literature, which includes earth batteries, atmospheric electricity, telluric currents, and pressure system changes.

The energy from continuous motion is considered fantastical forces. These devices utilize quantum vacuum energy, quantum vacuum perturbation, magnets.

1.2                                             OBJECTIVE OF THE PROJECT

The objective of this research is to:

• The main objective of system is the utilization of gravity using the
• The primary step for this is to increase ratio of input speed to output speed.
• The secondary step is to use the energy generated by the generator to the load bank.
• Obtaining the maximum output and calculating the maximum efficiency of the working
• explore the free energy option as a way to salvage the power generation

1.3                                         SIGNIFICANCE OF THE PROJECT

why motor company are not using magnet in both the rotor and in stator part so that it automatically runs and operates at least small devices and which will helps the peoples where electric transmission is not. The most importance of this device is that it generates electricity without the need for non-renewable energy source.

1.4                                          ADVANTAGES OF THE PROJECT

1. It is very Eco-Friendly.
2. It is very Economical for domestic purpose.

• It can get one rid off Power Supply Companies for one time investment.

1.5                                                   AIM OF THE PROJECT

The concept of Free Energy Generator can be used for generating electricity without using any Fossil Fuel, and any other mean, which means to generate Free Electricity.

1.6                                                 SCOPE OF THE PROJECT

In this method, an alternator is coupled with an Induction motor. Which is powered by an external source of energy for Initiation of the process. Once the process has been started, electricity generated is switched as a supply of the Motor which is running the Alternator, which make them Mutually Powered or Self Powered.

1.7                                               BENEFIT OF THE PROJECT

A free generator has several benefits that make it a good choice for a renewable home power system.  These include:

• Small size
• Low maintenance
• Durability
• Continuous operation
• Constant electrical output
• Self-powering
• Safe to operate
• Eco-Friendly
• Can provide 30%-50% of home electricity

1.8                                              LIMITATION OF THE PROJECT

A free generator does have a few limitations, however.  These include:

• Breakdowns are possible
• Limited electrical output
• Rare
• Expensive

1.9                                         METHODOLOGY

To achieve the aim and objectives of this work, the following are the steps involved:

1. Study of the previous work on the project so as to improve it efficiency.
2. Draw a wiring and circuit diagram.

• Test for continuity of components and devices,

1. Design and calculation for the device was carried out.
2. Studying of various component used in circuit.
3. Finally, the whole device was cased and final test was carried out.

1.7                                                         PROJECT ORGANISATION

The work is organized as follows: chapter one discuses the introductory part of the work, chapter two presents the literature review of the study, chapter three describes the methods applied, chapter four discusses the results of the work, chapter five summarizes the research outcomes and the recommendations.