The Environmental Waste Management And Control In Petrochemical Industry (PDF/DOC)
Click the button below to request the ‘COMPLETE MATERIAL,’ ‘Table of Contents,’ ‘Abstract,’ or ‘Chapter One’
Similar Topics (Recommended)
92 Pages
|
12,200 Words
The production of the soap was carried out using all the necessary equipments like the reactor, mould, stirrer, hygrometer guage etc. and all the required reagents for soap production in correct proportion. In the production, palm kernel oil (P.K.O) was used instead of tallow or grease. This was because soap produced from grease or tallow tends to dissolve slowly at room temperature, whereas, soap of palm kernel oil product gives a qui […]
85 Pages
|
8,424 Words
The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence. On this ground, a preliminary experiment was performed. During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflor […]
104 Pages
|
13,648 Words
The sole aim of this research work is to produce a high quality of bar soaps and compare with detergent. The major aspects of this projects deals with quality control processes in the production of a high quality bar soaps. In soap production, cold process was used and this was found out to be the most effective means of production considering several factors. In the production of bar soaps, palm kernel oil was used instead of fallow […]
55 Pages
|
5,756 Words
The fresh cassava were sources from Idodo in Nkanu Local Government of Enugu state. The weight of the cassava tuber were taken to be 31.50kg. After peeling and washing, it was divided into two equal parts which was 21.13kg for production of sample A and sample B respectively (edible and textile starch) which weighed 13.1kg. During this process, the temperature were obtained at 700c (617.4R). And the other properties of the cassava sam […]
69 Pages
|
9,600 Words
This project “production of plane mirror using local raw material” is meant to study the possibility of producing plane mirror using sand rich in silica as its major local raw material. Plane mirror is produced by casting one side of a sheet glass. Presently in Nigeria, sheet glass is not used easily produce and as such, the local raw material used in the in the production of plane mirror in this product backing paint. The facilities f […]
75 Pages
|
9,155 Words
INTRODUCTION BACKGROUND OF STUDY Agricultural credit in Nigeria dates back to the 1930s. But organized credit to farmers, but it did not start until 1772 when Nigerian agriculture and co-operative bank (N.A.C.B) was established. The awareness of the serous decline in agricultural production was partly responsible for the establishment of the bank. The N.A.C.B was not the only financial institution, which provides agricultural credit. P […]
34 Pages
|
4,741 Words
INTRODUCTION This study intent to look into what the federal government agriculture policies has done in putting food on the tables of the Nigeria citizenry which the Enugu north local government area as a case of study; also it seeks to know how farmers have benefited from the credit schemes, water resources, policies, inputs and mechanization, in duding information by extension workers concerning the new improved system of agricultur […]
This study on the Environmental Waste Management And Control In Petrochemical Industry is relevant to students and researchers in the following fields:
Agricultural Science (416)