Design And Construction Of An Over-Heating Indicator For Water Pipe
Chapters: 1-5 | Type: Project
Overview
ABSTRACT
The hot water pipe from the water geyser of your bathroom may burst if it gets overheated and is left unattended. This overheating indicator circuit monitors the temperature of the water pipe. If the temperature of the pipe goes above a certain limit, it flashes an LED. The circuit uses a small sensor with an inbuilt thermostat. It is actually an automatically resettable thermal switch that operates whenever its temperature exceeds the set limit. It is available in two versions, viz, normally open (N/O) and normally closed (N/C).
TABLE OF CONTENTS
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWLEDGEMENT
ABSTRACT
TABLE OF CONTENT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
1.2 AIM OF THE PROJECT
1.3 OBJECTIVE OF THE PROJECT
1.4 SIGNIFICANCE OF THE PROJECT
1.5 PURPOSE OF THE PROJECT
1.6 APPLICATION OF THE PROJECT
1.7 ADVANTAGES OF THE PROJECT
1.8 PROBLEM/LIMITATION OF THE PROJECT
1.9 PROJECT ORGANISATION
CHAPTER TWO
2.0 LITERATURE REVIEW
2.1 REVIEW OF RELATED STUDIES
2.2 REVIEW OF RELATED TERMS
CHAPTER THREE
3.0 CONSTRUCTION METHODOLOGY
3.1 SYSTEM CIRCUIT DIAGRAM
3.2 SYSTEM OPERATION
3.3 CIRCUIT DESCRIPTION
3.4 SYSTEM CIRCUIT DIAGRAM
3.5 CIRCUIT OPERATION
3.6 IMPORTANCE AND FUNCTION OF THE MAJOR COMPONENTS USED IN THIS CIRCUIT
3.7 POWER SUPPLY UNIT
CHAPTER FOUR
RESULT ANALYSIS
4.0 CONSTRUCTION PROCEDURE AND TESTING
4.1 CASING AND PACKAGING
4.2 ASSEMBLING OF SECTIONS
4.3 TESTING
4.4.1 PRE-IMPLEMENTATION TESTING
4.4.2 POST-IMPLEMENTATION TESTING
4.5 RESULT
4.6 COST ANALYSIS
CHAPTER FIVE
5.0 CONCLUSION
5.1 RECOMMENDATION
5.2 REFERENCES
Click this button to request for the Design And Construction Of An Over-Heating Indicator For Water Pipe complete material
Chat on WhatsApp to Request MaterialSimilar Project Materials
- Design And Construction Of Hotel Building In Nekede Community
- Design And Construction Of A Central Wireless Switch That Controls The Entire Appliances
- Design And Construction Of A Single Phase Auto-Transform Of Rating IKVA, 240V/110, 80 12V, 6V
- Design And Construction Of Control System For Direct-On-Line Starting Of Induction Machine
- Construction And Design Of 12 Volt Car Battery Charger Circuit With Phone Charging USB Port
- Design And Construction Of A Power Supply Restoration Alarm With 555 Timer, Buzzer And Led
- Design And Construction Of An FM Radio Receiver