The Design And Wireless Of A Panic Alarm System Complete Project Material (PDF/DOC)
ABSTRACT
Wireless panic alarm system is a full proof method to secure a building. The panic alarm system consists of panic alarm buttons and sirens. These panic buttons located at rather, strategic locations inside building premises. Moreover, high volume siren receivers spread across the building. While there is an event of an emergency, a person can alert the security personnel by mere pressing of a button. The panic siren system also has provision for handheld remote control units. Therefore, on press of remote controller, the building staff gets alerted. Then, respective panic button point shows up on the receiver console. It is possible to have more than one receiver consoles for the staff to know the panic point. Moreover, there is no limitation to the range of communication. And finally, boosters can help enhancing the signals kept at intermediate locations.
TABLE OF CONTENTS
COVER PAGE
TITLE PAGE
APPROVAL PAGE
DEDICATION
ACKNOWELDGEMENT
ABSTRACT
CHAPTER ONE
1.0 INTRODUCTION
1.1 BACKGROUND OF THE PROJECT
- PURPOSE OF THE PROJECT
- AIM OF THE PROJECT
- OBJECTIVE OF THE PROJECT
- PURPOSE OF THE PROJECT
- LIMITATION OF THE PROJECT
- ADVANTAGES OF THE PROJECT
- PROBLEM OF THE PROJECT
- APPLICATION OF THE PROJECT
- RESEARCH QUESTION
- PROJECT ORGANISATION
CHAPTER TWO
LITERATURE REVIEW
- OVERVIEW OF THE STUDY
- REVIEW OF THE RELATED STUDY
CHAPTER THREE
3.0 CONSTRUCTION METHODOLOGY
3.1 BASIC OF THE SYSTEM
3.2 BLOCK DIAGRAM OF THE SYSTEM
3.3 SYSTEM OPERATION
3.4 CIRCUIT DIAGRAM
3.5 CIRCUIT DESCRIPTION
3.6 DESCRIPTION OF COMPONENTS USED
3.7 POWER SUPPLY UNIT
CHAPTER FOUR
4.0 TESTING AND RESULTS
- CONSTRUCTION PROCEDURE AND TESTING
- INSTALLATION OF THE COMPLET DESIGN
- ASSEMBLING OF SECTIONS
- TESTING OF SYSTEM OPERATION
- COST ANALYSIS
CHAPTER FIVE
- CONCLUSION
- RECOMMENDATION
- REFERENCES
Advantages
- No wiring
- Installation not needed
- Maintenance free devices
- Moreover, units are modular
- Works on wireless technology
- Scalable system
- High noise level sirens
- Wall mount and handheld panic buttons
- No limitation to the range of communication
Applications
- Alarm system for old age homes
- Women safety in hostels and buildings
- Office emergency alarm systems
- Building panic alarm buttons
- Residential and gated community alarms
- Sirens in yards and factories
- Wireless alert in schools and colleges
Panic alarm button
100 meters range
Each panic button, needs to mount at strategic locations inside a building. However, in a situation of emergency or panic, a person needs to press the nearby alarm button. As a result, the whole building and security will get an alert, with various sirens and alarms. Thus, it gives a sense of security and satisfaction in the mind of residents. Moreover, system runs on wireless technology. Therefore, it becomes possible to have many panic buttons without wiring. The signal range is 20-30 meters indoors and rather 100-120m outdoors.
2.0 LITERATURE REVIEW
2.1 Introduction
The chapter presents a review of related literature that supports the current research on the Design And Wireless Of A Panic Alarm System, systematically identifying documents with relevant analyzed information to help the researcher understand existing knowledge, identify gaps, and outline research strategies, procedures, instruments, and their outcomes…
This Research Work On “Design And Wireless Of A Panic Alarm System” Complete Material Can Be Downloaded Through Whatsapp, Email Or Download Link. Click The Below Button To Proceed:
This study on the Design And Wireless Of A Panic Alarm System is solely for academic research purposes only and should be used as a research guideline or source of ideas. Copying word-for-word or submitting the entire project work to your school is unethical academic behavior and “UniProjects” is not part of it.