Development And Use Of Nonwood Plant Fibers In Pulp And Papermaking

Download Complete Material

The Development And Use Of Nonwood Plant Fibers In Pulp And Papermaking (PDF/DOC)

Chapter One

INTRODUCTION
This chapter introduces the Development And Use Of Nonwood Plant Fibers In Pulp And Papermaking and its relevance, states the research problems, research questions, and objectives, provides a background of the study, and should also include the research hypothesis…

Chapter Two

LITERATURE REVIEW
This section presents a review of related literature that supports the current research on the Development And Use Of Nonwood Plant Fibers In Pulp And Papermaking, systematically identifying documents with relevant analyzed information to help the researcher understand existing knowledge, identify gaps, and outline research strategies, procedures, instruments, and their outcomes…

Click the button below to request the ‘COMPLETE MATERIAL,’ ‘Table of Contents,’ ‘Abstract,’ or ‘Chapter One’

Related Field(s):

Chemical Engineering (247), Industrial Chemistry (238)

Similar Topics (Recommended)

Effect Of Interface On The Quality Of Petroleum Product In Multi Purpose Pipeline System.

80 Pages

|

10,247 Words

Interface on petroleum product in multi-purpose pipeline system refers to as the zone of demarcation between two products where mixing occurs. Generally, interface is a boundary layer, so the boundary between two products when they are pumped in succession is known as interface. In Nigeria Petroleum Industries like NNPC (PPMC) make use of multi-purpose pipeline system. This is where interface comes in petroleum products. Interface as […]

Fabrication Of A Pressurized Kerosene Oven.

53 Pages

|

3,751 Words

The fabrication of a pressurized kerosene oven. This project has been fabricated with special economical needs for the small scale baking industries, wholesalers and distributors who import this type of baking oven from outside the country to supply the customers. Who wish to use it or those that cannot after gas oven can be used in baking any type of available within the tropics. It I am also be used in are where there are no source o […]

Formulation And Production Of Levera Soap.

92 Pages

|

12,200 Words

The production of the soap was carried out using all the necessary equipments like the reactor, mould, stirrer, hygrometer guage etc. and all the required reagents for soap production in correct proportion. In the production, palm kernel oil (P.K.O) was used instead of tallow or grease. This was because soap produced from grease or tallow tends to dissolve slowly at room temperature, whereas, soap of palm kernel oil product gives a qui […]

Production of Alkali Using Local Raw Material (palm inforescence).

85 Pages

|

8,424 Words

The project aims to develop a flow process to obtain the optimum temperature and time necessary for the maximum recovery of alkali present in palm inflorescence. On this ground, a preliminary experiment was performed. During this process, both male and female palm inflorescence were compared for maximum alkali production and it was observed that the female palm inflorescence produced highest quantity of alkali than the male palm inflor […]

Production Of Domestic Powder.

72 Pages

|

8,771 Words

This research project is aimed at producing domestic powder and consequently, three different types of powder were produced, namely, simple face powder (pan-cake), medicated/Antiseptic powder (dristing powder). During the various production Talcum, Zinc-oxide, Perfume, Menthol, Tragasan 300 DP (Triclosan), Mineral oil and colour (brown) were the materials used in the production of different powders. And equipment and apparatus used for […]

The Steam Boiler.

43 Pages

|

6,436 Words

1.0 INTRODUCTION Boilers are pressure vessels designed to heat water or produce steam which can then be used to provide space heating and/ or service water heating to a building. In most commercial heating applications, the heating source in the boiler is a natural gas fired burner. Oil fired burners and electric resistance heaters can be used as well. Steam is preferred over hot water in some applications, including absorption cooling […]

Construction Of Steel Cupboard.

72 Pages

|

9,930 Words

A workshop cupboard is a facility designed from mild steel for the storage of various materials, like book material and non-book materials e.g. workshop tools, labouratory wares and reagents, etc; after operations in a chemical labouratory, mechanical workshop, or else where. The construction of a workshop cupboard requires the consideration of lots of characteristics of the materials, which are used for the construction, such as physi […]

This Study On The Development And Use Of Nonwood Plant Fibers In Pulp And Papermaking Is Relevant To Students And Researchers In Chemical Engineering
Industrial Chemistry And Related Fields.