44 Pages
|
5,111 Words
The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective gadgets like cut out switches; to give the 200W expected. The solar panel was mounted outside the b […]
104 Pages
|
13,648 Words
The sole aim of this research work is to produce a high quality of bar soaps and compare with detergent. The major aspects of this projects deals with quality control processes in the production of a high quality bar soaps. In soap production, cold process was used and this was found out to be the most effective means of production considering several factors. In the production of bar soaps, palm kernel oil was used instead of fallow […]
100 Pages
|
13,257 Words
This project “The Production of Ceiling Board from Local Raw Materials” was carried out basically using raw materials which was sourced locally. These raw materials are found to be very much in abundance. Some are materials sourced from the ground and others are from agricultural wastes. Three different types of ceiling boards were produced, their difference being in the type of fibre that was used. The fibres used for this different […]
60 Pages
|
8,367 Words
A smart fan is designed with op-amp is quite useful for conference halls, auditoriums, cinema halls, and other commercial organizations where many people gathered together, and lot of fans are required at these places. Depending up on the weather condition, organizers of the above places are supposed to be control each and every fan, otherwise lot of energy will be wasted. Controlling each and every fan manually is highly impossible; t […]
40 Pages
|
5,750 Words
An electric standing fan includes a fan shaft driven by a fan motor supported by a motor support. An oscillating device includes a rotational shaft connected to the motor support for driving the motor support to oscillate. A transmission gear has an axle connected to the rotational shaft and a gear wheel mounted around the axle and driven by a synchronous motor. An oscillating angle limiting switch detects a rotational angle of the rot […]
40 Pages
|
5,648 Words
Cell phones need electric sources to charge their batteries in order to work, but there are people in developing and third world countries that find it hard to access electric sources. In an attempt to provide an alternative means of charging to those unfortunate areas in third world and developing countries, a solar powered cell phone charging booth is to be designed and constructed in this project. The goal of this project is to cre […]
42 Pages
|
6,731 Words
Countries like Nigeria are plagued with erratic power supply that has lingered on for decades. A major feature of the Dry Season in Nigeria is thermal discomfort which is more pronounced at night due to lack of electricity from the Power Holding Company of Nigeria to operate AC powered electric fans. This research work describes the development of a rechargeable electric fan that operates on a 240V AC power source as well as a recharge […]