44 Pages
|
5,111 Words
The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective gadgets like cut out switches; to give the 200W expected. The solar panel was mounted outside the b […]
45 Pages
|
4,655 Words
INTRODUCTION 1.1 THE BACKGROUND Welding is a way of heating pieces of metal using electricity or a flame so that they melt and stick together. It can simply be defined as the process of joining two or more pieces of metal to make the act as a single piece. This is often done by melting the work pieces and adding a filler material to form a pool of molten material that cools to become a strong joint. Because of its strength, welding is […]
28 Pages
|
3,777 Words
This project is titled the design and construction of a DC to AC inverter system. It is designed to meet up with the power demand in the offices and in homes in the absence of power supply from the national supply authority, NEPA. In order words the device / item serves as a substitute for NEPA which almost monopolises the power supply to people. It is designed in such a way that it will take up 12v DC from battery and inverts it to an […]
31 Pages
|
3,579 Words
INTRODUCTION All modern engineering system include certain aspects of control systems at some point in their broadcast sense, control engineering and the associated theory are concerned with the means by which systems may be made to behave an a desired way. The system on this thesis is a DC – AC converter, which is an apparatus which is used for conversion of Direct Current to Alternating Current or signal. In our country, this equipme […]
70 Pages
|
8,363 Words
A 1.25KVA (2000W) inverter generator was designed, constructed and certified Ok. In this project, the design of the inverter generator is aimed at satisfying the need of converting, a D.C source of supply (12v battery) to an A.C voltage of 220v. The inverter range of output is between 200-220v. Since the inverter was designed to step-up voltage, the power transformer is being used as step-down transformer for charging and as step-up tr […]
49 Pages
|
7,070 Words
A battery charger is an electrical device employed for charging batteries. These batteries that are usually charged by battery charger are the storage batteries also known as “accumulator” the battery charger changes. The alternating current forms the power line into d.c suitable for charging. When the battery is fully changed, is up to it’s maximum, 12 volt, the charger with automatically cut-off with the help of the contact relay […]
43 Pages
|
6,224 Words
A training device for instructing students in inverter circuits, which includes a large flat panel that is vertically disposed for visual display before the students, locations on the front surface of the panel for attachment of digital devices, `a number of digital-logic circuit devices having means for both mechanical and electrical connection to the panel, a power circuit associated with the panel for energizing the electronic devic […]